www.lennoxhearthproducts.com
126544-01A
19
INSTALLATION
Continued
Figure 33 - Back and Middle Buttons
Configuration
Change
Back
Yes
No
0.5°C
Thermostat
Programming
Gap Temp
Fri 22:05
Off
Pairing
Configuration
Select Back
Off
No
Yes
0.5°C
Thermostat
Programming
Gap Temp
Fri 22:05
Pairing
Back
Button
Middle
Button
INSTALLING LOGS
WARNING: Failure to position
the parts in accordance with these
diagrams or failure to use only
parts specifically approved with
this heater may result in property
damage or personal injury.
CAUTION: Do not remove
the data plates attached to the
heater base assembly. The data
plates contain important safety
and warranty information.
1. Place fiber ramp log in center of chassis
as shown in Figure 34. The fiber ramp log
can be identified by the shape and much
lighter weight when compared to the other
logs. The log must sit flat on the black
sheet metal and behind the left metal tab
as shown in figure 34a. Make sure the side
marked ''BOTTOM'' is setting down.
Figure 34 - Installing Fiber Ramp Log
Ramp Log
Metal
Tab
2. Place front left and front right logs as shown
in Figure 35.
Figure 35 - Installing Left/Right Front Logs
Left Front
Log
Right Front Log
Press the “Back” button once to return the
highlighted selection to “Pairing”. Press the
“Middle” button and release. The indication on
the “Pairing” will become “Off” (see Figure 33).
The re-pairing is over. To return to the main
screen, press the “Back” button until you get
to the main screen. The main screen is shown
in Figure 28, page 18.
Figure 34a - Installing Ramp Log
Ramp
Log
Metal Tab
f i r e - p a r t s . c o m
