LEMKEN EurOpal, Operating Manual

Page: 10 / 69

Safety Instructions
8

The release ropes for quick coupler latches should hang freely and in the low-
ered position must not release the quick coupling by themselves.

Never leave the driver's seat whilst in motion!

Handling behaviour, steerability and braking are influenced by mounted imple-
ments, trailers and ballast weights. Check for sufficient steerability and braking!

When driving round bends note the width of the machine and/or changing cen-
tre of gravity of the implement.

Put implement into operation only when all guards are fixed in position!

Never stay or allow anyone to stay within the operating area!

Never stay in the turning and slew area of the implement!

Do not operate any hydraulic controls while anybody is in the operating area!

On all pivoting parts actuated by power assistance (e.g. hydraulics) exists dan-
ger of injury by bruising and crushing!

Before leaving the tractor lower the machine to the ground. Apply the parking
brake, stop the engine and remove the ignition key!

Do not allow anybody between the tractor and implement if the parking brakes
are not applied!

Swing attachment arm to transport position and secure!
Attached Implements

Before mounting or dismounting implements on/from the three-point linkage,
move the raise / lower control to the position at which accidental raising or low-
ering cannot take place!

In the case of three-point linkage mounting, ensure that the tractor balls and
the mounting pins of the implement are of the same category!

There is the risk of injury from pinch and shear points in the three-point linkage
area!

When operating the external lift controls for the three-point linkage, do not
stand between the tractor and implement!