Use
18
4.4
Length of the Top Link
Lower plough and adjust length of top link, so that the first body is approx. 1 to 3
cm higher than the rear one.
When the top link is fitted
“
in
”
the slotted hole, it must be adjusted with lowered
plough until the top link pin is unloaded but is still positioned in front of the slotted
hole and the plough is also 1 to 3 cm higher in front than in the rear.
4.5
Depth Control Wheel resp. Depth and Transport Wheel
Adjust the depth control wheel / depth and transport wheel to obtain the intended
working depth.
Swing the wheel rearwards against its stop and measure the vertical distance be-
tween wheel and ground. Make adjustments as required.
4.6
Clearance for the Turnover Operation
Raise the plough fully and then turn the
plough carefully.
Check whether there is sufficient clearance
between plough/depth wheel and ground.
If not, lengthen the inner turnbuckle (1), set
drawbar deeper, fit top link to a higher hole
in the headstock or use an hydraulic frame
swing-in assy.
When a Memory ram is fitted, the plough
frame can 1
st
be swung-in and 2
nd
the front
furrow width can be adjusted from the trac-
tor seat.
1
Summary of Contents for EurOpal
Page 2: ......
Page 15: ...Warning Stickers 13 2 3 Position of the Warning Stickers...
