2 MOUNTING BEHIND THE TRACTOR
The 3-point headstock of the SPLENDIMO 165 and 205L
disc mowers matches a category I and II linkage (fig. 3).
- For category II: fit the filler bush on the outer linkage pin.
The headstock of the SPLENDIMO 205L(HD), 240L, 280L
and 320L disc mowers is fitted with adjustable linkage pins
(category II) for adjustment of the offset position of the
machine behind the tractor (fig. 4).
- Adjustment of the linkage pins should be so selected that
the first mowing disc is entirely offset from the track of the
tractor tyre. Lock the linkage pins by means of the securing
bolts.
Attention!
The securing bolt has to be put into the hole of
the linkage pin and be turned into the nut up to the bolt
head.
Always use position
when mowing down a descending
slope so that you can operate as far from the side as possible.
- Adjust the tractor 3-point hitch lower arms at equal height.
- Fit the lower arms to the linkage pins of the machine’s
headstock.
- Fit the tractor top link to the machine.
- Lift the headstock to such an extent that the hinge pin of the
intermediate chassis (fig. 5) is approx. 55 cm above ground
level.
- Place the parking jack in the raised position.
- Secure the tractor lever arms by means of stabilisation
chains or rods keeping the mower from making sideward
movements.
- Check if the PTO shaft telescopes smoothly.
- Fit the PTO shaft to the tractor PTO shaft.
At first assembly or use of another tractor: check the
minimum and maximum overlap of the PTO shaft halves
*)
.
Fit the safety chain of the protection tube to a rigid part of
the tractor
.
- Connect the hydraulic hose to a single acting hydraulic
tractor valve. Max. allowed oil pressure: 17,5 MPa (175
bar).
*)
Consult the instruction supplied with the PTO shaft
.
31
!
5
55 cm
3
165L
205L
4
205 L (HD)
240L
280L
320L
