LELY SHUTTLE XY, Operator'S Manual

Page: 41 / 63

Maintenance 6-1
D-H021.1011EN
innovators in agriculture
6. MAINTENANCE
6.1 Clean the SHUTTLE
Special Tools
•
Bucket with cold water
•
Bucket with warm water
•
Teeth brush (or comparable brush)
•
Sponge
•
Alkaline cleaning agent, for example soap
Preparation
Note:
The SHUTTLE must be cleaned after each sampling to avoid pollution and to
ensure uncomplicated operation.
1. Make sure the fill head is not in a bottle (the 'up' position).
2. If the fill head is in a bottle, disconnect the CAN-bus cable from the
E-Link connector on the bottom of the multiple function box and
connect it again.
The fill head goes to the 'up' position.
3. Disconnect the CAN-bus cable from the E-Link connector on the
bottom of the multiple function box.
4. Loosen the fasteners (11) and open the cover of the SHUTTLE.
5. Remove the second rack (2).
6. Remove the first rack (1).
7. Close the bottles.
8. Remove the sample box from the SHUTTLE.
9. Find the syringe (12) that is attached to the lower side of the
SHUTTLE.
10. Disconnect the milk tube from the elbow.
Flush and clean the tubes and the fill head
1. Use the syringe to flush the internal parts of the SHUTTLE with cold
water:
1. Install the syringe (3) in the milk tube (2).
2. Flush the milk tube and the fill head (4), while you push up
and release the bottom side of the fill head to close and open
the valve.
3. Flush the milk tube and the fill head again.
4. Remove the syringe from the milk tube and install it in the
bleed tube (1).
5. Flush the bleed tube.