LELY SHUTTLE XY, Operator'S Manual, Page: 44 / 63

7-2 Test and Adjustment
D-H021.1011EN
innovators in agriculture
7. Close and lock the cover of the SHUTTLE.
If the cover can not be closed, make sure the racks are installed
correctly and try again.
Connect the E-Link and Start-up
1. Connect the E-Link manual controller to the E-Link connector on
the SHUTTLE.
2. Push the middle soft button and hold it.
3. Connect the CAN-bus cable from the E-Link connector (3) on the
bottom of the multiple function box.
A dot starts blinking on the display of the SHUTTLE.
4. Release the middle soft button on the E-Link.
5. Select the menu 'Application' and push [ ].
6. Remove the CAN-bus cable to the E-Link connector at the bottom
of the multiple function box and connect it again.
The E-Link displays the application menu.
7.2 Test the SHUTTLE
1. On the E-Link, select the menu '#*#Test menu', 'Go to position'.
2. Use buttons [ ] and [ ] to select position 81 and push [ ].
3. Make sure the level measure pins are in the bottle.
4. If the measure pins are not in the bottle:
1. Remove the CAN-bus cable to the E-Link connector on the
multiple function box and connect it again.
2. Do the calibration procedure (page 7-2).
3. Repeat the test procedure.
5. Remove the E-Link.
7.3 Calibrate the SHUTTLE
1. On the E-Link, select the menu 'Settings menu', 'Set the offset'.
The fill head moves to the calibration position (position 56).
2. Move the fill head to a position exactly above the bottle 56 with
the soft buttons [x] and [y].
3. Move the fill head into the bottle 56 with the soft button [z].
4. Make sure both level measure pins are in the bottle.
5. Push [ ] two times.
The fill head moves to the home position.
6. Move the fill head into the bottle 0 with the soft button [z].
7. Make sure both level measure pins are in the bottle.
8. Push [ ] two times.