LELY WELGER V 160, Operating Manual, Page: 43 / 80

WELGER • V 160 35
5.2 Adjusting the twine brake
The twine brake must hold the twine as taut as possible to
ensure that the twines are tight around the bale.
(Figure 24) Adjust dimension "X" of the twine brake
according to the following table.
Basic setting
Length "X" of the spring
(Figure 24)
Twine A 39 mm
Twine B 37 mm
Note!
•
(Figure 23) The permissible thread tension is exceeded
when the twine breaks in the vicinity of the guide rollers [8].
•
(Figure 24) The dimension "X" is measured between:
washer bottom edge and the bottom surface of the cranked
plate.
Figure 24