COMMISSIONING
LELY WELGER
y
RPC 445 Tornado
55
7.11.2
Adjusting the height of the drawbar
Attention!
The height adjustment of the machine and thus the
adjustment of the drawbar and of the hitch may be changed
only by the manufacturer or an authorised special workshop.
Place the machine on a horizontal ground.
Using the crank handle raise or lower the support foot until
the distance from the ground to the top edge of the running
gear frame is 1190 mm (Figure 29).
Measure the height of the drawbar coupling on the tractor.
Measure the height of the drawbar on the machine.
(Figure 31) Adjust drawbar in the hole pattern to ensure that
the drawbar of the machine and the drawbar coupling of the
tractor are at the same height. Important: Replace safety
nuts whenever they have been loosened!
(Figure 30) Tighten fastening screws and nuts: 300 Nm.
Figure 30
Figure 31
Summary of Contents for RPC 445 TORNADO
