SAFETY
20
LELY WELGER
y
RPC 445 Tornado
3.3
General safety instructions
Even if all warnings and safety instructions are observed the
machine involves secondary hazards which cannot be
eliminated by constructional measures. Always handle the
machine with care to avoid danger to yourself and others!
Before starting work perform a visual inspection of the
machine. Check whether any device has been changed or
is missing and pay attention to any unusual noise or leaks
which occur during operation.
In case of all work on movable parts or in the range of
action of movable parts: Switch off power take-off shaft,
switch off tractor engine, remove ignition key and
disconnect drive shaft from power take-off shaft end, and
interrupt electrical connection between tractor and machine.
When carrying out work on the opened tailgate: insert tail gate
safeguard (see chapter "Tailgate Safeguard", page 26).
When carrying out work on the wrapping ring folded up:
insert wrapping ring safeguard (see chapter "Wrapping
Ring Safeguard", page 28).
When carrying out work in the vicinity of the net knife: insert
net knife safeguard (chapter "Net Knife Safeguard", page 27).
When carrying out work in the vicinity of the film knife:
cover film knife with the guard hood included in the delivery
(chapter "Film Knife Cut Protection", page 27).
Never remove any crop material from the machine while the
drive is running, or while the disconnected machine is still
moving.
Maintenance work may be carried out by trained expert
personnel only.
Never step onto the maintenance platform during machine
is in motion. Before stepping on the maintenance platform:
stop machine, switch-off power take-off shaft and tractor
motor and wait for standstill of the machine.
When opening the tailgate keep a minimum distance of 2 m
from electrical high-voltage lines.
When folding up the wrapping ring keep a minimum
distance of 2 m from electrical high-voltage lines.
For travelling on public roads, the drive shaft must always
be plugged onto the tractor p.t.o. shaft and engaged.
Riding on the machine is prohibited for the entire machine!
During operation: Never climb the drawbar or any other
parts of the machine. Keep sufficient distance to baler
(pick-up, running gear, bale unloading area). Keep
sufficient distance to the range of action of the round bale
Summary of Contents for RPC 445 TORNADO
