Leitronic AG EasyAlarm BASIC, User Instructions, Page: 4 / 32

4
2. SAFETY INSTRUCTIONS
2.1 Approval
Declaration of Conformity
According to the R&TTE Directive 1999/5/EC of 09.March 1999
Manufacturer’s Name: Leitronic AG
Manufacturer’s Address: Engeloostrasse 16
CH-5621 Zufikon, Switzerland
declares that the product
Product Name: EasyAlarm
Model Number: EA-8-EXT
conforms to the following product specifications:
Safety (R&TTE, Article 3.1a): EN60950: 1992+A1+A2+A3+A4
EMC (R&TTE, Article 3.1b): EN 50081-1, 1992
EN 50082-1, 1997 Class B
Telephone: CTR21 as specified in Council Decision 98/482/EC
Supplementary Information
The product herewith complies with the requirements of the following Directives and carries the CE marking accordingly:
the EMC directive 89/336/EWG
the Low Voltage Directive 93/68/EEC
Zufikon, 1. April 2008 Silvan Tognella
2.2 Telephone connection
EasyAlarm®
is designed to connect to an analogue telephone line. This connection should remain in service after a mains
power. These are:

analogue PSTN

analogue port of an ISDN terminal (ISDN-NT has to be reprogrammed for emergency operation at the ab-port)

analogue port of a private exchange using UPS (Uninterruptible power supply 1h buffering)

GSM Interface with approval, i.e. EA-GSM-Interface from Leitronic.
Not suitable:

Voip or cable modem, as in case of power loss it is not functional!
The voltage of the telephone network is defined in EN 41003. It is higher than 40 V and therefore please beware for
electrical hazard and disconnect
2.3 Power supply
A transformer according to the safety regulation EN60950 provides power supply. 9V battery is used as a back up in case
of power failure. It is located on the rear side oft the device.
2.4 Safety notes

Do not bring the device into contact with a liquid (water).

Do not open the device (exception: opening of battery compartment).

Replace the 9V-battery as soon as the announcement “battery error” is announced.

Please note: The telephone cord must be disconnected before opening the battery compartment because
otherwise you can get in contact with the telecommunication voltage!

Check alarm functions and start a test-call , before the system is put in service.

In case that
EasyAlarm®
is used to monitor children, the supervising person must be in a suitable distance to
take immediate care for the child.
EasyAlarm®
does not replace personal supervision!

The same applies to handicapped persons,
EasyAlarm®
is not a substitute of a personal care taker!

An alarm by telephone is only successful if the alarmed party takes care of the following points:

Alarm must not be answered by an answering machine or equal equipment

Mobile phones can be out of range (e.g. underground car park, shielded rooms, remote areas..)

Take care of the charging condition of the mobile phone

Loud noise can prevent you from hearing the ringer

All the electrical connections have to be potential free. Observe the regulation according to EN60950.