27
10.8.2 Remote programming of calling number and calling number sequence
If remote programming is enabled calling numbers/sequence can be re-programmed during
phone connection:
1. Enter DTMF * *
n
(
n
=> see chart below)
Current calling number/ calling number sequence will be announced. If you want to change, continue at point
two. otherwise enter DTMF # .
2. Enter DTMF *
3. Enter new number/sequence
After entering of the last digits, wait ten seconds. New number/ sequence will be announced, followed by the
request to enter
DTMF
n
to confirm change. If you do not confirm within 10 seconds or if another key is
pressed the message „programming: abort“ will be announced. In this case the old value remains active.
<
n>
Comment
Programming according to
0
Calling number sequence (max. 9 digits)
Section 6.2
1
Calling number I (max. 24 digits)
2
Calling number II (max. 24 digits)
3
Calling number III (max. 24 digits)
Section 6.1
#
SPECIAL - CASE: Phone connection is terminated and a test call is initialised with the current calling number
sequence and calling numbers => announcement: “Alarm due to programming“