14
6.2 Designation of the calling number sequence
6.2.1 Standard sequence
Alarm triggered
Calling number 1
Alarm not acknowledged
by called party 1
Calling number 2
alarm not acknowledged
by called party 2
same for calling number 3 to 9
The alarm is acknowledged by pressing DTMF 0 (
section 7.7.5).
The alarm is passed to next party immediately by pressing DTMF 8 or after
connection time-out
.
6.2.2 How to program calling number sequence
1.
Slide
function switch
to PROG
2.
Enter
* * 0
.
Current calling number sequence will be announced followed by “to modify press
*
, to stop press
#
“
3.
To maintain the current programming, go to point 5. Otherwise enter
*
.
.
4.
Enter the desired sequence (max. 9 digits)
5.
Slide
function switch
to OFF
Sample for programming calling number sequence:
a)
’123’ => calling number 1 will be dialled, followed by calling number 2, followed by calling number 3.
b)
’111133322’ => first calling number1 will be dialled (4 call attempts are made), followed by calling number 3 (3 call
attempts are made), followed by calling number 2 (with 2 call attempts).
Notes:
The calling number sequence is factory set to ‘123456789’, but a general
reset according to section 10.1 will NOT
RESET the calling number sequence!
In case of an un-programmed or deleted calling number, the calling number sequence will continue with the next
number of the sequence.
If a dialled number is busy and another call attempt is programmed, the
waiting period
before re-dialling is 30 sec.
If the calling number changes within the sequence, dialling of a new number starts without delay
6.3 How to select user language / How to record individual message
An individual announcement can be recorded as follows:
1.
Shift
function switch
to PROG
2.
Enter
* * #
.
Current individual message will be announced followed by “to modify press
*
, to stop press
#
“
3.
Select language for user announcements: (facultative)
Press key
1
to
4
according to desired user language (i.e. 1=DE/2=FR/3=GB/4=IT)
4.
Press
*
and start speaking
5.
Press
#
to finish recording, max. duration is 12 seconds
New individual message will be announced
6.
Shift
function switch
to OFF
Note:
Repeat step 3 and 5 until you are satisfied with individual message.
6.3.1 Remote recording of individual message during handsfree connection
1.
Enter DTMF * * # #
Current individual message will be announced followed by “to modify press * , to stop press # “
2.
Select language for user announcements: (facultative)
Press DTMF 1 to DTMF 4 according to desired user language (i.e. 1=DE/2=FR/3=GB/4=IT)
3.
Start recording by sending DTMF * , start talking (max. 12 s) and finish by sending DTMF #
.
New individual message will be announced
4.
Wait until the message “Abort” confirms the end of the programming
Note:
Remote recording can be enabled / disabled according to section 10.8.1.
if called party 3 does not acknowledge the alarm, the calling
number sequence is repeated the number of programmed alarm
repetitions times (
default value: two alarm repetitions
,
programming see section 10.2)