28
5
36
4
6
35
34
7
9
11
Risk of crushing and shearing
When operating the clamping lever and clamping arm, there is a risk of injury to the hand. Always hold
the hot wedge welding machine by the handles and control units provided.
Exceeding the maximum joining force
of 1000N can cause mechanical damage to the device.
• Unlock the
clamping lever lock (5)
and open the
clamping lever (4).
• Unlock the adjustment ring
lock (34)
on the
joining force module (6)
and turn the
adjustment ring (35)
coun-
terclockwise until the maximum opening of the
clamping arm (7).
• Place two
test strips (36)
of the material to be welded on top of each other between the
upper
and
lower
drive/pressure rollers (9/11)
and close the
clamping lever (4).
• Turn the
adjustment ring (35)
of the
joining force module (6)
clockwise until the
upper
and
lower
drive/
pressure rollers (9/11)
slightly clamp the
test strips (36).
• Unlock the
clamping lever lock (5)
and open the
clamping lever (4).
• Rotate the
adjustment ring (35)
clockwise while the
joining force module (6)
is open until the joining force
shown on the
working display (29)
matches the desired joining force with the
clamping arm (4)
closed and
the
test strips (36)
inserted. To do this, the
clamping lever (4)
must be opened and closed repeatedly.
• Lock the
adjustment ring lock (34)
on the
joining force module (6),
so that the joining force cannot be
adjusted unintentionally.
• Switch on the hot wedge welding machine via the
main switch (17)
once you have prepared the working
• After startup, the Start screen will appear briefly in the display with the device designation and the version
number of the current firmware release and the device designation.
• This is followed by the display of the setpoints of the last recipe used (the BASIC recipe is displayed when the
device is first commissioned).
Clamping lever (4)
closed
Clamping lever (4)
open
Adjusting the joining force
Starting the device
