Doc No. FM0600 issue I Page 10
17. REGISTERING A SENSOR CONTROLLER ONTO AN ADVENT xt WARDEN CALL
1. Put the Advent xt system into radio device learn mode…
2. Activate the sensor controller…
3. Exit the Advent xt system radio device learn mode…
4. Press the
CARER CALL
button and check the correct alarm call type is reported on the warden call system.
Deleting a Sensor Controller from an
Advent xt
warden call system
Press the
LINE
key and wait for the “
Ready
” prompt.
Enter
5 0 0 1
followed by the
key.
Enter the flat number the bed monitor is being deleted from followed by the
key.
Press the
CARER CALL
button on the sensor controller to be deleted.
Wait for the “
Pendant Disabled – Enter Flat
” prompt.
Press the
#
key and wait for the “
Ready
” prompt, then press the
LINE
key to clear the connection.
Refer to the Advent xt operators manual (Doc No. FM0420) provided with the warden call system for more
information on programming and testing radio devices.
Using the Manager’s DECT telephone;
Press the
LINE
key and wait for the “
Ready
” prompt.
Enter
5 0 0 0
followed by the
key.
Enter the flat number the sensor controller is being installed in
followed by the
key.
You now have 1 minute to activate the sensor controller.
“
Ready”
Using the Manager’s DECT telephone;
Press the
#
key and wait for the “
Ready
” prompt.
Press the
LINE
key to clear the connection and the warden call system is
now back in normal operating mode.
Press the
CARER CALL
button.
Wait for the “
Enter Location Code
” prompt then press
0
(no location)
followed by the
key.
Wait for the “
Pendant Enabled – Enter Flat
” prompt.
“
Ready”
