Doc No. FM0600 issue I Page 8
14. ADVANCED SETUP MODE - CONTINUED
From the
Advanced Setup
menu select
Clock Setup
then
press the
ENTER
key;
Clock Setup
Set Date 01:01:00
Set Day Mon
Set Time 00:00
Clock Setup
Auto BST
Exit
Set
Date
in DD/MM/YY format.
Set Day
– Mon to Sun.
Set Time
in HH/MM format using 24 hour clock.
Auto-BST
use the
keys to Enable
or Disable
aut/- 1 hour British Summer Time adjustments.
From the
Advanced Setup
menu select
Factory Setup
then press the
ENTER
key;
Factory Setup
Load Defaults
Program ID
Register Device
Factory Setup
I/O Setup
Exit
Load Defaults
and
Apply
to restore factory settings as below;
Date 01:01:00
Time 00:00 with Auto BST on
Sensor type: un-calibrated bed sensor
On all the time: No
Active start/stop time periods: all 00:00 (disabled)
Instant alarm: Yes
Delay before Alarm: No
Not in Bed Alarm: No
Still in Bed Alarm: No
Low Battery Beep: Yes
Program ID
to enter the last 6 digits from the product label.
Register Device
to learn the unit onto an at-home alarm,
warden call, carer call or Nursecall system.
I/O Setup
to choose a Pear Push or a Relay Output,
Use the
keys to Enable
or Disable
a
Pear Push
switch
(see section 22).
If the pear push is disabled you will get the option to set the
Relay On Time
from 0 to 99 seconds. The relay activates with
any alarm – N/O contacts on I/O socket pins 1 & 3.
Note: it is only possible to set a Pear Push or a Relay Output
(not both).
15. REGISTRATION MODE
The sensor controller must be registered onto an at-home
alarm, warden call, carer call or Nursecall system. The
simplest way to transmit registration data is to press the
CARER CALL
button.
)
)
)
)
)
)
)
See the following pages for how to put each of the above
products into “Learn Mode”.
The range of all radio devices can be affected by
the working environment. Always take care
during installation and perform several test calls.
“Bed
Occupancy”
