Doc No. FM0600 issue I Page 3
Door Frame
Door
2. HOW TO INSTALL A BED SENSOR
The Bed Sensor must be placed between the bed base and the mattress.
Check the base is in reasonable condition with a flat firm surface to lay the sensor on.
The sensor should be placed across the width of the bed at a point where the
hips of the person will be when lying down. Ensure the connecting cable
exits safely without causing a trip hazard.
Plug the lead into the sensor controller.
Spare Bed Sensor with 2m Lead: Product Code ZCS844
Dimensions: 650mm x 130mm x 10mm (LxWxD)
RJ45 Double Adapter (used to connect 2 bed sensors): Product Code P10285
3. HOW TO INSTALL A CHAIR SENSOR
The Chair Sensor must be placed between the seat base and the cushion.
Check the base is in reasonable condition with a flat firm surface to lay the sensor on.
The sensor should be placed across the width of the chair at a point where the
person will be sitting. Ensure the connecting cable exits safely without
causing a trip hazard.
Plug the lead into the sensor controller.
Spare Chair Sensor with 2m Lead: Product Code ZCS859
Dimensions: 325mm x 130mm x 10mm (LxWxD)
RJ45 Double Adapter (used to connect 2 chair sensors): Product Code P10285
4. HOW TO INSTALL A PRESSURE MAT
The Pressure Mat must be placed under the carpet or a rug
alongside the bed so it will be stood on when
the person gets out of bed.
The mat should be placed so the connecting cable exits
safely without causing a trip hazard.
Plug the lead into the sensor controller.
Pressure Mat with 2m lead is ordered separately: Product Code ZCS857
Dimensions: 520mm x 400mm x 6mm (LxWxD)
RJ45 Double Adapter (used to connect 2 pressure mats): Product Code P10285
5. HOW TO INSTALL DOOR CONTACTS
The Door Contacts should be installed by a
competent person on the frame
of the door being monitored.
Fix the contact (part with wire connected)
to the door frame. Clip the cable to the
door frame and route safely without
causing a trip hazard.
Fix the magnet to the door. There should
be no more than 10mm between the
Magnet
2 parts when the door is closed.
Plug the lead into the sensor controller.
Door Contact with 2m lead is ordered separately: Product Code ZCS854
RJ45 Double Adapter (used to connect 2 door contacts): Product Code P10285
Cable to Sensor Controller
