Doc No. FM0600 issue I Page 13
20. HOME/AWAY MODE
If the person is going to be away from home for more than one day you must select
AWAY MODE
to prevent false “not in bed” alarms.
When the sensor controller is in its normal operating mode the
key is used to toggle between
HOME/AWAY
mode.
Press this key once and the display will show;
The unit is now in
AWAY mode
After about 10 seconds the display will blank - during this mode no alarm calls will be sent.
REMEMBER: when the person returns home the sensor controller must be put back into the HOME mode.
Press the
HOME/AWAY
key once and the display will show;
The unit is now in
HOME mode
After about 10 seconds the display will blank - normal monitoring is now resumed.
21. CARER CALL FACILITY
The Carer Call facility can be used to raise an instant alarm call via the warden call system, at-home alarm or Nursecall system.
When the sensor controller is in its normal operating mode the
key is used to send a
CARER CALL
.
Press this key once and the display will show;
Unit is sending a
CARER CALL alarm
…… PLEASE WAIT……
After about 10 seconds the display will blank.
You will hear reassurance tones from the at-home alarm or warden call intercom when the call is being made.
22. OPTIONAL PEAR PUSH
The Pear Push switch option must be enabled in the
I/O Setup
– see section 14 (page 8).
Press and hold the Pear Push for more than 3 seconds to activate an alarm call
PEAR PUSH
Pear Push with 2m Lead: Product Code ZNC680
Tynetec and Aidcall operate a policy of continuous improvement and reserve the right to change product specifications without notice.
If any variation to the details contained in this document are suspected please contact Tynetec’s customer support dept on 01670 352371.
