12 / 14
EMS CX
3
- Signalling Auxiliary Contact
(CA + SD)
Cat. N°:
4 149 29
6. SYSTEM ARCHITECTURES
(continued)
6.2 Supervised system
(Computer Supervisory System)
(continued)
6.2.2 Supervised system with remote addressing (through a computer)
Remote addressing advantages:
-
Whole of configuration (addresses and functions) can be done a remotely through the EMS Configuration software
-
Configuration software available for free
-
Automatic detection of the EMS CX
3
modules installed in the system (characteristics, functions, configuration...)
-
Increased settings possibilities: load shedding function
-
Increased addressing: up to 32 Modbus/EMS CX
3
interfaces
-
Increased addressing: up to 247 Modbus addresses in a system
Programming procedure:
. For EMS CX
3
modules which need some: possible through the lateral DIP-switch of each EMS CX
3
modules (see § “Module configuration”).
Note: via the configuration software it is possible to assign all the functions and characteristics of each EMS CX
3
module
Addressing procedure:
. It is not necessary to address the EMS CX
3
modules. The track wheel must be left in default position “0”.
. All the addressing/configuring procedure will be done with the Configuration Software (available online for free)
. With remote addressing, the software does the automatic detection of modules installed in the system, but the supervision is not possible until
the user assigns the remote address and all the characteristics to each module.
Note: it is mandatory to connect the computer to the different Modbus/EMS CX
3
interface with an USB-micro USB cable (one interface at a
time).
[For more details, refer to the User Manual Document]
Technical data sheet: F02334EN/02
Updated: 07/11/2018
Created: 20/07/2016