28
FLUSH-MOUNTING
CABINETS
Cabinets are delivered with the rails of
the chassis in the upper position, i.e.
ready to install the modular products
(MCB) as well as the Vistop < 160A.
The plug-in function of the chassis allows
the rails to be adjusted and the products
to be installed outside the cabinet, on a
workbench or other. Wiring can thus be
carried out in the workshop, at the same
time as the cabinet is installed on site.
To remove the chassis from the cabinet,
remove the 4 10 mm nuts (2 at the top
and 2 at the bottom):
To replace the chassis, it must be
inserted on the 2 lower studs and then
on the 2 upper studs. Tighten the 4 nuts,
starting with the 2 top ones:
Lower part
1
DRX 125 MOUTNING (AVAILABLE
IN CERTAIN MARKETS)
To install these products, it is necessary
to place the rail in an intermediate
position and install the DRX using the
corresponding adapters:
- Cat.no 0 271 87 for DRX 125 3P & 4P
- Cat.no 0 271 89 for DRX 125 1P
- Cat.no 0 271 90 for DRX 125 2P
Remove the rail by loosening the 2
screws with a Torx T30 end cap:
Twist both lugs 90° inwards:
Before
After
Replace the rail with the 2 screws in
the holes provided and then install the
product.
Modular devices (MCB) can be mounted
next to a DRX. To do this, use the rail
extension Cat.no 3 382 41. After cutting
it to length (if necessary), clip it onto the
omega rail next to the DRX.
The depth is then correct to allow the
faceplate to be fitted.
Mounting devices
Summary of Contents for 3 372 02
Page 38: ...36 Notes...
