9
15. Adapter
Hole distance to mount console to wall::
5.2.1
Register Console with Access Point (AP):
The console must be first registered with the main AP, since the entire data
transfer is done through the main AP.
The factory setting is set so that the console is automatically registered at the
nearest AP.
Press the MENU button for 6 seconds. The display will show F.F.F.F. Press any
key to automatically register the console with the main AP.
5.2.2
Store the call number of Phone Call and Phone Bell at the Console.
1)
Press the MENU button for 1 second.
2)
The display will show
„CA.id“.
3)
Press the OK button. The display will show
„C001“.
4)
Use the number button
to enter the digit for the hundreds. Press OK.
5)
Use the number button
to enter the digit for the tens. Press OK.
6)
Finally enter the last single digit. Press OK.
7)
Then press the Phone Call (or Phone Bell) button within 4 seconds. You are
done.
8)
To control the success: Press the Phone Call (or Phone Bell) button and
verify that the Console displays the signal.
5.2.3 Response time to Phone Call signals
The factory setting is 7 seconds. You can choose response times between 1 and 10
seconds. That means: After the Phone Call signal comes in, the call must be
answered within this time interval. After this time interval, Phone Call is
automatically set to OFF, to put the device in energy saving mode.
To change the response time, see the "Co.rt" Menu for handset and console.
***
Note
*** Warn signal for battery replacement for Phone Call/Bell: If after the call
signal DingDong, a "PigPigPig" sound is heard, then you need to replace the
battery of the respective Phone Call/Bell.
5.2.4 Signal (only send signal) und Call (talk)
Signal from Console to Console/Handset (1 to 1):
