17
The factory setting is set so that the monitor is automatically registered at the
nearest AP.
Press the MENU button for 6 seconds. The display will show F.F.F.F. Press
any key to automatically register the monitor with the main AP.
The Phone Call System can also be used with an AP, if the call system only
consists of Monitor and Phone Bell. Also in this case, an AP can be installed
at a later stage to extend the transmission range.
To store the Phone Bell numbers with the handset see 5.3.2, with console
see 5.2.2.
Store Phone Bell number, if only Monitor and Phone Bell is use (without AP).
1) Press the OK button
for 1 second.
2) The display will show
„001“.
3) Use the Up(+) button
to enter the digit for the hundreds. Confirm with
the OK button
. Repeat the procedure for the digit for the tens and the
last single digit.
4) Confirm with the OK button
. The display flashes.
5) Press the Bell button. The monitor rings. Done!
Delete Phone Bell numbers
1) Press the OK button
for 1 second.
2)
The display will show „001“.
3) Use the Up(+) button
to enter the digit for the hundreds. Confirm with
the OK button
. Repeat the procedure for the digit for the tens and the
last single digit.
4) Confirm with the OK button
. The display flashes.
5) Press the Bell button within 4 seconds.
6) The display will show "000 00 00". The number is deleted
– done.
Selection of ringtone
1) Each time when you press the button
, the ringtone will change. The
selected ringtone is automatically saved.
Check saved ringtone
1) Press the Up(+) button
, to check whether the saved ringtone rings.
Set up ranges of bell numbers (e.g., if you use Phone Call separately for
separate floors)
1) Press the Up(+) button
for 2 seconds.
2) The display will show "001".
3) With the Up(+) button
, chose the start number and confirm with the
OK button
.
4) Now insert the end number. Confirm with the OK button
