14
2)
The display will show „CA.id“.
3)
Press the OK button. The display will show „C001“.
4) Use the number buttons
und
to enter the digit for the hundreds. Press
OK.
5) Now enter the digit for the tens. Press OK.
6) Finally enter the last single digit.Press OK.
7) Then press the Phone Call (or Phone Bell) button within 4 seconds. You are
done.
8) To control the success: Press the Phone Call (or Phone Bell) button and
verify that the handset displays the signal.
5.3.3 Response time to Phone Call signals
The factory setting is 7 seconds. You can choose response times between 1 and 10
seconds. That means: After the Phone Call signal comes in, the call must be
answered within this time interval. After this time interval, Phone Call is
automatically set to OFF, to put the device in energy saving mode.
To change the response time, see the "Co.rt" Menu for handset and console.
***
Note
*** Warn signal for battery replacement for Phone Call/Bell: If after the call
signal DingDong, a "PigPigPig" sound is heard, then you need to replace the
battery of the respective Phone Call/Bell.
5.3.4
Signal (only send signal) and Call (talk)
Signal from Handset to Console/Handset (1 to 1):
1) Press the CALL/CLR button
2) With the keys Up(+) (9) and Down(-) (10), enter the caller ID number.
"00" means: call all participants.
3) Press the OK button.
4) The signal reaches the addressee with vibration.
Call from Handset to Console/Handset (1 to 1)
1) Press the CALL/CLR button
2) With the keys Up(+) (9) and Down(-) (10), enter the caller ID number.
"00" means: call all participants.
3) Press the Call button
4) The signal reaches the addressee with vibration.
5) Press the "TTT" button (5): Keep pressed to talk, release to listen.
Note:
If the addressee does not pick up after the pre-set time of 7 seconds,
the ID number is automatically reset to "00". "00" means: Talking to all
participants.
5.3.5
Joint menu of Console/Handset
1.
CA.id
(Call id): Set the ID number of Phone Call/ Bell
