LeCroy PXA125, User Manual

Page: 99 / 219

User Manual PXA125
ArbConnection 3-85
Figure 3-49. The Waveform Screen
Notice on the left top and on the right top there are two triangles
pointing to the center of the screen. These are the anchors. The
anchors are used as the start and end pointers where your waveform
will be created. For example, if you want to create a sine waveform
between point 100 and point 500, you place the left anchor at point
100 and the right at point 500 and then generate the sine from the
built-in library.
There are two ways to control anchor placements.
1) Click and hold your mouse cursor on the left anchor triangle and
then drag the curtain to the left position. Do the same for the
right anchor. Notice the X and Y coordinates at the top of the
waveform screen and how they change to correspond to your
anchor placement.
2) You can also place your anchors in a more precise manner
from the waveform library by programming the start and end
points for the waveform. An example of anchor placement using
the sine dialog box is shown in Figure 3-17.