LeCroy LSA1000, Operator'S Manual, Page: 41 / 115

4 – 7
Note: The default Gateway is assigned as "172.25.0.1" unless
your network has this Gateway available, you must ensure the
computer and the LSA1000 are on the same subnet.
Changing IP Address
Once communication between the LSA1000 and host PC has
been verified, the IP address can be easily reset to any address
using the
Scope Explorer remote control software tool provided
in the Getting Started CD-ROM. To change the IP address,
initiate the following remote commands from
ScopeExplorer
’s
Terminal. These are described in the Remote Control Manual
(see Chapter 5 of the present manual).
➢
*IDN?
: Retrieves the unit’s name, serial number, and
software revision level.
➢
CONET?
: Returns the current IP address configuration
including the mask and gateway. Default is IP, "172.25.1.2",
Mask, "255.255.0.0", Gateway, "172.25.0.1".
➢
CONET IP,”172.25.1.5”,MASK,”255.255.0.0”,GATEWAY,”172.25.0.1”
:
Sets the IP address. This example changes the unit’s IP
address to 172.25.1.5.
Once the IP address is changed, the unit will no longer respond to
the original IP.
If the network settings are unknown or accidentally set to invalid
values, the factory default network settings can be recovered by
following the procedure below.
Restoring Default Network Settings
The factory default network settings can be
restored by powering-up the unit with the Ethernet reset jumper
closed. (The reset jumper is accessible through the small hole next
to the Ethernet connector).