LeCroy LSA1000, Operator'S Manual

Page: 35 / 115

4 – 1
4
Connecting to PC or Network
Connecting the LSA1000 to its Host
This chapter describes connecting the LSA1000 to the host
PC or network over the standard 10/100Base-T Ethernet.
Windows NT and Windows 95 operating systems are
supported. For more about the LSA1000 and the Ethernet,
see Chapter 3 of the accompanying Remote Control Manual.
PC Requirements
For acceptable operational performance with the LSA1000, the
following are the minimum PC requirements:
➢
Pentium class PC
➢
32 MB RAM
➢
10MB free disk space
➢
Windows 95 or Windows NT, and
➢
Ethernet Adapter supporting 10/100Base-T, with a standard
RJ45 connection.
Ethernet Connection
The LSA1000 operates over a standard 10/100BaseT Ethernet
connection. The instrument can be plugged into a network or
operated from a direct connection to a host computer. A different
type of cable is required for each of these connections. For a
direct connection of LSA1000 to PC, a
cross-over cable is
required, whereas the network connection is made using a
straight cable.
The LSA1000 has an IP address assigned to it at the factory: it
does not support Dynamic Host Configuration Protocol (DHCP)
or any other automatic address resolution scheme. This IP
address may be changed by the user after the connection has
been established.
The LSA1000’s factory-assigned IP address is:
172.25.1.2
The LSA1000's factory-assigned Mask is: 255.255.0.0
The LSA1000's factory-assigned Gateway is: 172.25.0.1