Operator's Manual
l
delta clock-to-data near (DC2D)
l
delta clock-to-data next (DC2DPOS)
l
delta clock-to-data previous (DC2DNEG)
l
delta delay (DDLY)
l
delta time at level (DTLEV)
l
phase (PHASE)
l
resolution (RES)
l
mTnTmT shift (BEES)
l
mTnTmT shift sigma (BEESS)
l
mTnTmT shift sigma – list (BEESS)
Set Up Math on Parameters
1. Touch
Measure
→
Measure Setup...
on the menu bar.
2. Choose Measure Mode
My Measure
.
3. Touch output
Px tab or button
to display the parameter setup dialog.
4. Touch the
Math on Parameters
button.
5. Touch
Math Operator
and select a math operation from the
Select Measurement
menu.
If you select an operation that requires two input parameters, the
Source1
field will expand to two
fields.
6. Touch
Source1
and
Source2
and select two input parameters (P1 to P8) other than the parameter you
are now setting up.
To apply math to a single parameter (for example, Invert), just select it in
Source1
.
7. Check
On
to enable the new output parameter and add it to the display.
Using Scripts
In addition to the arithmetic operations, you can write your own VBScript or JavaScript to apply to one or
two measurement parameters. When setting up the output parameter, choose the Math Operator
P Script
.
Scripting can be done in the
Script Editor
window directly on the instrument, or you can import an existing
script.
P
ARAM
S
CRIPT
V
S
. P S
CRIPT
Param Script is a VBScript or JavaScript that operates on one or two
waveforms
and outputs a parameter
measurement, as shown in the figure below. P Script, on the other hand, is another VBScript or JavaScript
that takes as input one or two
parameters
and performs a math operation on them to produce another
parameter output.
The inputs to Param Script can also be math (Fx) or memory (Mx) traces. The inputs to P Script can be
the results of any parameter measurement, not necessarily Param Script.
922499 Rev B
65
