• When OD is on, Botley will not move forward when he
“sees” an object—he’ll just stay in place and honk until
you move the object out of his way. Try
reprogramming Botley to go around the object.
Battery Information
When the batteries are low on power, Botley will beep
repeatedly. Please insert new batteries to continue using
Botley.
Installing or Replacing Batteries
WARNING!
To avoid battery leakage, please follow these
instructions carefully.
Failure to follow these instructions can result in battery acid
leakage that may cause burns, personal injury, and property
damage.
Requires:
5 x 1.5V AAA batteries and a Phillips screwdriver
• Batteries should be installed or replaced by an adult.
• Botley requires (3) three AAA batteries. The Remote
Programmer requires (2) AAA batteries.
• On both Botley and the Remote Programmer, the
battery compartment is located on the back of the unit.
• To install batteries, first undo the screw with a Phillips
screwdriver and remove the battery-compartment door.
Install batteries as indicated inside the compartment.
• Replace compartment door and secure with screw.
Battery Care and Maintenance Tips
• Use (3) three AAA batteries for Botley and (2) two AAA
batteries for the Remote Programmer.
• Be sure to insert batteries correctly (with adult
supervision) and always follow the toy and battery
manufacturer’s instructions.
• Do not mix alkaline, standard (carbon-zinc), or
rechargeable (nickel-cadmium) batteries.
• Do not mix new and used batteries.
• Insert battery with the correct polarity. Positive (+)
and negative (-) ends must be inserted in the correct
directions as indicated inside the battery compartment.
• Do not recharge non-rechargeable batteries.
• Only charge rechargeable batteries under adult
supervision.
• Remove rechargeable batteries from the toy before
charging.
• Only use batteries of the same or equivalent type.
• Do not short-circuit the supply terminals.
• Always remove weak or dead batteries from the
product.
• Remove batteries if product will be stored for an
extended period of time.
• Store at room temperature.
• To clean, wipe the surface of the unit with a dry cloth.
• Please retain these instructions for future reference.
6
2936 Botley Coding Robot GUD NBR4.indd 6
9/22/17 4:47 PM