USER INSTRUCTIONS
A. General
Leaksafe’s WaterComm Leak Detection and Leak Notification System comprises lengths of leak detection
tape installed in areas where leaks are likely e.g., behind your Kitchen sink & dishwasher, the Utility area
and under Baths, showers, WC’s and basins. The tapes are connected to the WaterComm device.
If the leak detection tape in any area gets wet, the WaterComm sends a signal to Leaksafe’s data
platform that will immediately send a SMS and/or email with the time the leak was detected, and where
the leak was detected.
The notifications will look like this:
SMS Notification:
Re: (Property & location e.g., XX House, Flat XX Kitchen)
Leak detected
Battery level: x:xx
Temperature: xx.xx
Humidity level: xx.xx
LeakSafe WaterComm Device
PLEASE NOTE
that the leak detection tape is deliberately sensitive and will activate with just a few drops
of water.
Email Notification:
From: [email protected]
Subject: Alert from Leaksafe
Date:
To:
This is a message from Leaksafe, reference:
RE: (Property & location)
Leak detected
Battery level: x.xx
Temperature: xx.xx
Humidity level: xx.xx
This is for information only -
please do not reply to this email
LEAK
SAFE
SOLUTIONS | WATERCOMM USER INSTRUCTIONS
PAGE 4
Connecting
cable
Leak
detection
tape
On/Off
Zone LED’s
