34
Wyvern Timer 2000R Operating Instructions
Profit Share Setup
This is performed by following the
Control Card Operation
procedure explained previously.
Once set to profit share the timer is ready for the Profit Card. When the correct Profit Card
has been inserted the timer will then work normally using coins, tokens or User Cards, but
cannot be programmed to change any of the program codes other than setting the real time
clock. In profit mode the timer is completely controlled by the settings applied via the Set
Timer to Profit Card.
Note:
1. You do not need to select the timer’s programming mode to enable profit share setup.
2. The PIN code must agree with the code used while programming the setup smart card.
3. Once a timer is set to profit mode, pressing the PROG button will display the total profit
remaining within the timer.
Using the Profit Card
The following procedure applies the first time you use a Profit Card or when you need to
top-up the sessions within a timer:
1. Insert the Profit Card, the timer’s display will indicate the number of sessions remaining in
the timer. For example, if the timer had four sessions remaining the display will show:
‘P_:04’ Programmed with 04 remaining sessions
2. Press the front panel DOWN button. Now enter the PIN code, as if you were entering a
program code and data. Using the UP and DOWN buttons select each digit and press the
front panel PROG button to confirm each digit entered.
3. Press the front panel PROG button once more and the timer’s display will flash between
‘Acc’ and the number of sessions now loaded into the timer. For example, if the Profit Card
contained another ten sessions the display would flash between ‘Acc’ and ‘P_:14’ indicating
the timer now contains another ten (fourteen in total) sessions.