Wyvern Timer 2000R Operating Instructions
29
Money Interrogation Options
The following codes become available when the timer is set to the interrogation mode using
the UP button. Note: Although codes 00 to 02 have been used in the program menu the
following selection codes relate to the interrogation menu.
Money Collected Values
When you select one of these codes, the data values displayed ‘xx’ will indicate the
accumulated money values recorded by the timer.
Selection
Codes
Description Maximum
Value
Value Used
00
Total money xx in hundreds of
base currency
-
01
Total money xx in units of base
currency
-
02
Total money xx in hundredths
of base currency
-
Stored Total Value Programming Codes
To reset the total time and total money values to zero, the internal programming switch must be
set to the programming mode before pressing the UP button. All the code data values must then
be set to zero (selection codes 00 to 05 inclusive). The timer will only allow data values of ‘00’
to be entered (reset), if any other value is attempted the timer reverts to the original data setting.
Return the programming switch to normal for the reset to take effect. If any one data value is not
set to zero the original data values are retained for selection codes 00 to 05 inclusive.
Example
Suppose the following figures were obtained from a timer set to operate with dollars and
cents:
selection code 00 gave a value of 02 (100 X 02=200 dollars)
selection code 01 gave a value of 59 (1 X 59=59 dollars)
selection code 02 gave a value of 50 (0.01 X 50=0.5 dollars or 50 cents)
So the total takings reported would be (200+59+0.5) $259.50.
