diamond - User Manual
Version: 8.0.0/1
Exported on: 24 October, 2023
207
/
228
1.
2.
3.
1.
2.
3.
1.
2.
3.
'Settings -> Source Input'
This tab opens the 'Source Input' page. It can be used to assign a Power Core input to a
source.
It is designed so that any Line, Ravenna or MADI input can be assigned to the more generic sources, such as Playouts and
Codecs. The page is divided into two halves: Sources (on the left) and Destinations (on the right). The available sources
and destinations are defined by the configuration. Note that, in this instance, the Sources are all Power Core inputs, and the
Destinations are "sources" that can be assigned to a fader strip.
On the left, the Sources are divided into categories using the side panel tabs. On both sides, you can page through the
available options using the up/down arrows beside "Page x of y".
To interrogate the existing connections:
Under 'Destinations', use the up/down arrow buttons to select a page.
If a destination is connected, then the source name appears below the output. For example, the Power Core input "In
Rav 01" is connected to the source "Play 01".
If a destination has no source, then you will see two dashed lines.
To make a connection:
Under 'Sources', select an input category and page, and choose a source - the selection flashes in blue.
Under 'Destinations', select a page and choose an output - the selection flashes in blue.
Press
Connect
-
the connection is
made.
To disconnect an output:
Under 'Destinations', choose the output you wish to disconnect - the selection flashes in blue.
Under 'Sources',
select
No Source
.
Press
Connect
-
the source is removed.
