Lavorwash Lavor Pro FREE EVO 50E, Manual

Page: 34 / 120

If you do not complete the configuration procedure,
the settings remain as they were originally.
(
!
) We recommend to call the assistance centre or
a technician if you have problems with the settings
given.
Do not open or tamper the electronic board.
5.2 BATTERY CHARGER CONFIGURATION
(
!
) We recommend to call the assistance centre or
a technician if you have problems with the setting
given.
The machine is equipped with a battery charger
configurated for GEL batteries
If the operator whish to use Pb-Acid battery, it is
necessary change the battery charger settings as
follows:
(
!
) DISPLAY OF THE BATTERY CHARGER SET-
TINGS
The battery charger settings are shown by the
blinking of the LED indicator when the battery
charger is switching on:
- the RED LED indicator ( Photo M - 2 )
flashes 2 times
= the battery charger is set for
PB-Acid batteries
- the GREEN LED indicator ( Photo M - 3 )
flashes 2 times = the battery charger is set for
GEL batteries
The battery charger settings will be displayed even
if batteries are not connected.
(
!
) DIP-SWITCH CONFIGURATION FOR PC-
ACID/GEL BATTERY CHARGING CURVE
To set the charging curve type for Pb-Acid or GEL
batteries it is necessary to
operate on a dip-
switch placed inside the battery charger (
Photo M -4 ) .
The dip-switch available for the setting of the
charging curve is on the control card ( Photo M - 4
) that is placed behind the lower panel of the bat-
tery charger ( Photo M - 1 ). It is also possible to
reach the dip-switch by removing the plastic cap (
Photo M - 5 ).
Starting from left to right, the dip-switch available
for the setting of the charging curve is the first one,
that is indicated by number
1 in dip-switch SW1
( Photo M - 6 ) .
NOTE: the position of all the remaining dip-switches
must NOT be changed .
6. OPERATING INFORMATION
6.1 MACHINE PREPARATION
(
!
) Before starting to work, wear non-slip shoes,
gloves and any other personal protection device in-
dicated by the supplier of the detergent used or
considered necessary based on the operating envi-
ronment.
(
☞
) Do the following before starting to work. Refer
to the relative sections for a detailed description of
these steps:
Heck the battery charge level and charge, if neces-
sary.
34
Pb-Acid GEL Signaling Signaling ACTION
24,0 24,0 Green LED ON LED ON All working
21,5 22,5 Yellow LED ON LED ON All working
20,5 21,5 Red LED ON LED FLASHING Brush motor is
not working
20,0 21,0 Red LED
FLASHING
LED FLASHING All motors are
not working
Volts
Battery Type
Battery power
test indicator
LED
Brush operation
indicator LED
Battery discharge indicator and functions - MODEL “BT” (DC 24V with traction)
Position of Dip-switch
SW1 - number 1
Charging curve
ON Charging curve for
PB-Acid batteries
OFF Charging curve for
GEL batteries