Lavor SWL R 1300, Instructions And Operating Manual

Page: 67 / 292

67
Figure 44
14.4. CENTRAL BRUSH
OPERATION TO BE PERFORMED WITH THE ENGINE OFF AND COLD WITH GLOVES,
SAFETY GOGGLES AND RESPIRATORY PROTECTION DEVICES. ONLY PROCEED WITH
THE INSPECTION AFTER INSERTING THE SAFETY BAR (PARA. 4.4.1).
Every 50/80 hours of work or when required, check the good condition of the central brush ( Item 2 Figure 3
para.3.4) , in particular if it is assumed that it has inadvertently collected cords, wires, etc .
To proceed with the inspection of the central brush:
1 . lift the waste container and then turn off the engine and electrical services.
install the safety bar (para . 4 .4 .1 )
proceed with the inspection .
Figure 45
If it is necessary to replace the central brush:
Open the right side hatch (Item 1 Figure 45)
Disassemble the right flap stop (Item 2 Figure 45)
Move the flap (Item 3 Figure 45)
Remove the screw (Item 4 Figure 45)
Remove the support arm (Item 5 Figure 45)
Remove the old brush (Item 6 Figure 45)
To complete the assembly, perform the operations described in reverse, being sure to respect the brush
interconnections during reassembly (Figure 46) .
Adjust the height of the new brush as described in paragraph 9 .2 .