Lavor SWL R 1300, Instructions And Operating Manual

Page: 62 / 292

62
Figure 40
9.3. SIDE BRUSH ACTION ADJUSTMENT
OPERATION TO BE PERFORMED WITH THE ENGINE OFF AND THE ELECTRICAL
SERVICES DISABLED.
When the side brush is being used or to adjust its action on the surface:
Use the screw ( Item 1 Figure 41 ) to adjust the height of the brush . The lower the screw, the lower the brush .
When the desired height is reached, lock the position by tightening the ring nut ( Item 2 Figure 41 )
Figure 41
NOTE: If necessary, remove the side brush protection ( Item 3 Figure 41 ) and reassemble it when the adjustment
is complete .
CHAPTER 10 - SAFETY RULES
10.1. GENERAL RESIDUAL RISKS
DEFINITION : The residual risks that cannot be eliminated are all those that, for various reasons,
cannot be removed, but for each of which we report the indications to operate in the context of
maximum safety.
•
Risk of injury to the hands, body and eyes if the machine is used without all the safety protections
correctly fitted and intact.
•
Risk of injury to the hands from touching the side brush or the central brush for any reason during
rotation. The brushes can only be touched with the engine off and with the aid of protective gloves to
avoid being pricked or cut if in the bristles there were pointed splinters of debris in general .
•
Risk of inhalation of harmful substances, abrasions to the hands due to emptying of the waste container
without using protective gloves and mask to protect the respiratory tract .
Risk of not being in control of the machine should it be used on slopes greater than those indicated in paragraphs
3 .10 and 5 .1, or of it not being properly stopped when left parked .
Risk of explosion or fire from refuelling with the engine on or with the engine off but not completely cold.
Risk of serious burns from performing any maintenance with the engine on or engine off but not completely cold.
Risk of inhalation of exhaust gas when used in an inadequately ventilated environment .
10.2. GENERAL RISKS FOR ACID BATTERIES
•
Before charging, check that the room is well ventilated or charge in rooms that may be used for this
purpose .