39
IMPORTANT: To ensure the central brush is correctly adjusted, measure its “Track” as
follows:
-
After adjustments, start the machine up and, and without moving either forwards or backwards, leave it
standing in the same place for at least 10 / 15 sec. with the central brush lowered.
-
Turn off the engine, raise the central brush and move the machine forwards manually until the mark left
on the floor by the rotation of central brush is visible, as shown in Fig. 17 .
IMPORTANT: The width of the track must not be under 4 cm.
SIDE BRUSH ADJUSTMENTS:
When the side brush Part. 1 Fig. 18 is no longer able to convey dirt to the central brush, the height of the
side brush will have to be adjusted as follows:
-
Keeping the side brush raised turn anticlockwise the register Part. 3 fig. 8 .
IMPORTANT: This operation must be performed with the engine switched off.
COLLECTION BIN:
Every 50 / 60 working hours or whenever necessary, wash the collection bin Part. 1 Fig. 7 using warm water
and, if necessary, common detergent. This will prevent any bacteria build-up (wear rubber gloves) .
•
GENERAL RULESTo ensure a good machine functioning and life-span, keep both the outer
bodywork and the inside of the machine, under the bonnets, clean by using jets of compressed
air (perform this operation with the engine off and cold).
REPLACEMENTS
REPLACING THE CENTRAL BRUSH:
This operation must be performed wearing gloves and a face mask to protect the airways. Use 10 /
13 / 17 mm spanners and make sure the engine is off and cold.
1.
Remove the left panel (left to the driving seat) Part. 4 (Left) Fig. 3, by loosening the retention screws.
2.
Remove the 3 bolts on Part. 7 and 9 of Table 1 .
3.
Remove the screws securing the left panel Part. 13 Tab. 1 to which the side seal is also fastened.
4.
Pull out the central brush Part. 15 Tab. 1 and proceed to replace this being careful to ensure the brush
bristles are in the right direction as shown in Fig. 17. Ensure the drive notches of the two brushes
supports Part. 4 and 24 (see Tab. 1) are inserted in the brush housing Part. 15 Tab. 1 .
5.
To end assembly, repeat the operations in the reverse order.
6.
Adjust the height of the new brush (see “CENTRAL BRUSH ADJUSTMENT” paragraph).
REPLACING THE SIDE BRUSH:
This operation must be performed with the engine off and wearing gloves, using two 10 mm spanners.
1.
Unscrew the three bolts Part. 4 Fig. 18 to detach the side brush Part. 1 Fig. 18 from the plastic flange
Part. 5 Fig. 18 .
2.
Replace the worn brush and screw up the bolts Part. 4 Fig. 18 to the flange Part. 5 Fig. 18 .
SWL R1000 ST/SW R 8300 SC
Summary of Contents for SWL R 1000 ET
