64
INSTALLATION AND MAINTENANCE MANUAL
554515_A_PUB_DATE_1_FEB_2014.DOC
ADJUSTING ON THE SIDE OF THE DOOR HINGE, FIGURES 5.11.A., 5.11.B
IF THE ADJUSTMENT AT THE DOOR HANDLE SIDE IS INSUFFICIENT, IT IS NECESSARY TO PERFORM
ADJUSTMENT AT THE DOOR HINGE SIDE.
1. Loosen two bolts (6) fastening the top door hinge (7).
BE CAREFUL TO AVOID POSSIBLE FALLING OF THE DOOR WITH LOOSENED HINGE TO THE FLOOR.
RISK OF INJURIES!
2. Take off the elimination washer (8).
3. Tighten the two bolts (6) fastening the top door hinge.
4. Do the same with the bottom hinge.
5. Check if the door hinge has not moved, closing and opening of the door must be smooth.
If the thrust adjusting has not been sufficient, exchange the door seal.
5.12. SPRING UNIT
MACHINES 33-40-55 kg / 80-100-125 lb
Spring units (figures 5.12.A., pos.1) are to be adjusted in the case that you found out the suspended machine
part is not in a horizontal position (without linen and water) or after the spring unit has been replaced.
WARNING!
MAIN SWITCH MUST BE OFF!
The spring unit adjusting is achieved by turning the nuts (2) with the same number of turns always simultaneously
on the opposite guiding rods (3) of spring unit.
The adjustment is correct when a same gap in all four corners of the suspended machine part has been achieved,
(X = 55 mm / 2.16“) between the plate edge (4) of the vibrating part and the frame top surface (5).
1. Spring unit
2. Adjusting nuts
3. Guiding rods
4. Suspended part
5. Machine frame
6. Spring suspension eyes
Figure 5.12.A. – Machines 33-40-55 kg / 80-100-125 lb
!
Summary of Contents for LH-550
Page 2: ......
