554515_A_PUB_DATE_1_FEB_2014.DOC
INSTALLATION AND MAINTENANCE MANUAL
19
2.1. SYMBOLS ON THE MACHINE
See User's manual.
2.2. IMPORTANT INFORMATION BEFORE INSTALLATION
FOR TRANSPORTATION AND STORAGE
IN CASE OF TRANSPORTATION AND STORAGE, WATCH COMPONENTS PROTRUDING FROM THE
CONTOUR LINE OF MACHINE (DOOR LOCKS ETC.), TO AVOID INJURIES.
– Never push, pull or exert pressure on components protruding from the machine contour line (controls,
door locks etc.).
– Make sure that these components are secured so as to avoid damages during machine manipulation
and installation.
– In case of the machine transportation by the customer, follow the manufacturer's instructions for transportation,
handling and storage of the product. In case of transportation of machine by the customer the manufacturer
is not responsible for possible damage of machine in the course of transportation. In case of storage the machine
in a free area it must be protected against mechanical damage and weather condition factors.
FOR INSTALLATION
ALL CONNECTION, AND IN SPECIAL PROTECTING EARTH, MUST BE PERFORMED BY QUALIFIED
PERSONNEL WITH A PROPER AUTHORIZATION ACCORDING THE INSTALLATION MANUAL IN COMPLIANCE
WITH LOCAL STANDARDS.
– The washer must not be installed or stored in an area where it will be exposed to water and/or weather.
Avoid damp conditions where water or moisture could run down the walls and covers of the washer or cover
the floor around the washer. Do not install the washer above an open gutter. Close any nearby gutters
so that waste water steam cannot collect near/inside the washer.
– Any changes in the machine installations must be approved by dealer or manufacturer. Otherwise the dealer/
manufacturer is not responsible for possible injuries or damages. Interference and changes in the machine
construction are not allowed and the manufacturer refuses any responsibilities in such cases.
– Define dangerous areas in the laundry room and do not allow people to enter if the machine is in operation.
MACHINE INFORMATION
– This manual comprises information for the soft - mount machine series with a dry load of 33-40-55-80-100-120 kg /
80-100-125-180-230-275 lbs. Verify the machine model according to your order and the data plate and find
corresponding information in the manual.
– The machines are controlled by electronic controller. Find the programming instructions in the programming
manual.
– Additional heating can be provided by electrical heating elements or by steam from an external steam supply.
– Water inlets can use warm, cold soft and possibly also cold hard water.
– On request a machine can be equipped with:
recycle discharging,
dosing pumps for liquid soaps,
weighing system (further referred to as “weighing”),
tilting system – with forward tilting,
– with two-way tilting (forward and backward) - 80-100-120 kg / 180-230-275 lbs machines only.
– Electrical setup of the machine is indicated on data plate.
Summary of Contents for LH-550
Page 2: ......
