![background image](http://html1.mh-extra.com/html/launch/kes-200/kes-200_manual_3875700058.webp)
LAUNCH KES-200 PC Link
H-3
Fig.7-47
Manually input the firing order, and press [ENTER]
key. The screen will be displayed as shown in
Fig.7-48.
Fig.7-48.
Note:
Make sure to input the correct firing order; if a
wrong firing order is inputted, the screen will
display error information. For example, if mistake
is made as that shown in Fig.7-49 (two “1” are
inputted), the screen will prompt the error as
shown in Fig.7-50 after [ENTER] is pressed.
Fig.7-49
Fig.7-50
Follow the prompts on the screen to start the engine.
It will take about 5 or 7 seconds for cranking. When
the engine is started, the screen will automatically
display the result of the relative compression test for
the cylinders, as shown in Fig.7-51.
Fig.7-51
Note:
♦
During the relative compression test, the
cranking time will be a little longer. Do not
interrupt. 5 or 7 seconds later, the engine will
be automatically started.
♦
After the engine is started, the screen will be
displayed as shown in Fig.7-52. KES-200 is
collecting data now. If the cylinder 1 signal
cable is not connected properly, the screen
as shown in Fig.7-53 will be displayed.
Connect the cylinder 1 signal cable properly
and test again.
♦
If the engine cannot be started after long
time of cranking (over 10 seconds), stop it
and check the unit and cable connections.
♦
If the engine cannot be started after 50
seconds, the screen will be displayed as
shown in Fig.7-53. In this case, you must
press [ESC] key to exit, and then re-enter
and try the test again.