LAUNCH KES-200 Multimeter
C-1
Brief Introduction
KES-200 has 4channel oscilloscope function. It can
be used to measure the output waveform of the
sensors on vehicle and display 4 waveforms at the
same time. The help information in the system
includes standard waveforms that are the reliable
basis for analyzing the fault of various vehicle sensors
by comparing them with the waveforms being tested.
Specifications
Item Specification
Signal type
DC/AC
Measuring range
DC-150V~+150V
Measured frequency
500kHz (Max)
Time DIV
25
µ
s~20s
Voltage DIV
0.1V~20V
Automatic setting
The DIV for time and
voltage is automatically
adjusted according to the
inputted signal.
Display freezing
Display can be frozen
Magnification 5
times
(Max)
Waveform storage
50 pages online storage,
8 pages offline storage
Connection
Four oscilloscope cables and one ground cable are
provided with the unit. Refer to Fig.2-01 for cable
connection of oscilloscope.
1
2
3
4
5
6
7
8
Fig.2-01
1.
KES-200 main unit
2.
Engine analysis cartridge
3.
Battery
4.
Battery cable
5.
Ground cable
6.
Oscilloscope cable
7.
Sensor to be tested
8.
Main cable
Configuration of Oscilloscope Function
z
KES-200 main unit (1PCS)
z
Engine analysis cartridge (1PCS)
z
Main cable (1PCS)
z
Battery cable (1PCS)
z
Oscilloscope cable (4PCS)
z
Ground cable (1PCS)
Getting Started
How to Enter Oscilloscope
Insert the engine analysis cartridge into the main unit.
Then switch on the main unit. The unit will enter the
start interface. On the start interface, press any key
(except [Reset], [Power] and [Exit]), the screen will
display the main menu as shown in Fig.2-02.
