Laski LS 160, Operating Instructions Manual

Page: 12 / 55

Chipper LS 160T
12
them in the chute and push them forward between the loading rolls by means
of a wooden stick or a board, more than 160 cm long, to push materials
between the loading rolls.
 Should the pressing stick be indrawn between the roles, do not try to pull it out
by hand - accident risk! Use always a new stick and go on working.

While working wear always personal protective equipment - protecting shield
or goggles, protective gloves, working shoes and working cloth properly
buttoned. Avoid wearing free parts, such as ties, scarves and shawls, belts etc.
In case of longer hairs use always a proper head piece. Otherwise, such a
person is not allowed to operate this machine.
 While working, wear always personal protective aids - protecting shield or
goggles, protective gloves, working shoes and working cloth properly
buttoned. Avoid wearing free parts, such as ties, scarves and shawls, belts etc.
In case of longer hairs use always a proper head piece. Otherwise, such a
person is not allowed to operate this machine.
 In case of two attendants it is necessary to make simple signals clear before
working and to appoint one who will manage the work. Both attendants must
be properly trained in attendance and turning the chipper off in emergency
cases.
- Keep traffic lights and work safety symbols in proper order.
- Check materials to be loaded and remove all undesirable objects. If you see
such particles in ejected chips, stop working immediately.
- Never load materials with parts of metal, glass and other similar objects (metal
wires, nails etc.).
- This manual describes problems and faults which could occur at work and
which may be remedied by an instructed person. In case of other problems and
faults do not hesitate and contact the manufacturer. He is always ready to help
you.
- Never do any technical changes or any actions which are neither given in this
manual nor allowed by the manufacturer. The machine, not correctly installed
or adjusted, may run without problems now but in the future it could damage
any of important parts. Pay regular attention to all joints and bolts. Keep them
properly tightened.
- Do not put any objects or tools on the machine.
- The manufacturer does not bear responsibility for any damages or injures
caused to the third persons or to other equipment resulted from disobedience
to instructions given in this manual.
- When handing the machine over to another person make sure if all controls,
guards and other safety elements are complete and fully functional.