Laski LS 160, Operating Instructions Manual

Page: 26 / 55

Chipper LS 160T
26
- Do not try to repair the machine if it is beyond your competence. Any
servicing, especially of rotating parts, should be carried out by authorised
persons only.
- Check conditions of blades. Replace them if worn or damaged.
- The chipping wheel can be optionally completed with a breaker. According to
the material to be chipped install/remove a breaker on/from the chipping
wheel.
- For replacement use always original spare parts. Parts, such as rotors and
blades, must be balanced properly.
- All blades should be replaced always at the same time as a set. Pay special
attention to their fixing bolts. Replace them if worn or damaged.
- Hydraulic oil and oil filters should be changed regularly.
- Do not use petrol or similar inflammable matters as a cleaning agent.
- It is strictly forbidden to do any technical changes on the machine without any
prior approval of the manufacturer in writing.
- If any adjustment is required, do it always at standstill only. Remember
blocking the wheels against unwilling motion.
- Check conditions and proper tightening of V-belts.
- It is strictly forbidden to start the chipper with removed hoods and guards.
Coupling to Tractors
This chipper can be coupled to a tractor which is equipped with a three-point hitch,
category I or II and a PTO shaft.