Laser Technology TruPulse 200X, User Manual

Page: 22 / 62

Laser Technology, Inc. TruPulse 200X User's Manual 1
st
Edition
Page 18
Neck Strap
1. Find the two Attachment Points located on the rear panel of the TruPulse 200X.
2. Insert the end of one of the connector straps into one side of the eyelet opening
and feed it through to the other side.
3. Feed the strap up from the bottom of the buckle, then over the center of the
buckle and back down through the other side.
4. Pull the strap to take up any slack and tighten the strap to simply have a loop
that is fed through the eyelet.
5. Repeat steps 2-4 to attach the other connector strap to the other side of the
TruPulse 200X.
6. Attach one end of the neckstrap into the side release buckle of one of the
connector straps.
7.
Attach the other end of the neckstrap to the side release buckle of the other
connector strap.


Make sure the strap is straight when attaching it to the TruPulse 200X.
This will help you avoid uncomfortable twists in the strap that will rub
your neck.

Before use, check to make sure the neckstrap is secure. Failure to do so
may result in the TruPulse 200X hitting the ground or other object.

The neckstrap may also be attached to the carrying case.
Serial Port
The TruPulse 200X includes a serial port located on the front panel and allows the
instrument to download measurement data. See
page 44 for more information on the
serial data interface.
Figure #11