Laser Technology TruPulse 200X, User Manual

Page: 13 / 62

Section 2 – Quick Start
Page 9
Section 2 - Quick Start
1.
Install the battery (page 10) .
2.
Press to power ON the TruPulse 200X.
3.
Select a target such as a wall across the room
or a nearby tree. For this example, the target
should be approximately 10 meters (33 feet
or 11 yards) from you.
4.
Look through the eyepiece (see Figure #3)
and use the crosshair to aim to the target. The
in-scope LED should look similar to Figure
#4A.
o
If the HD indicator is not displayed,
press
or until the HD indicator is
displayed.
5.
Press-and-hold . The laser indicator
is displayed and flashes while the laser is
active (Figure #4B). The laser will remain active
for a maximum of 10 seconds while acquiring
data about the target.
o
If the target is not acquired, release
and repeat this step.
6.
Release once the distance is displayed
(Figure #4C). The measurement will be displayed
steady until you press a button
or the unit powers OFF.
o
Press or to scroll through the
measurement modes and see the results
acquired for each function.
o Repeat steps #3-#6 above to take another
measurement.
o
Simultaneously press-and-hold and
for 4 seconds to power OFF the TruPulse
200X.
Figure #3
Figure #4