Laser Technology TruPulse 200X, User Manual

Page: 19 / 62

Section 3 - Basic Operations
Page 15
Error Codes
Error conditions can occur in a measurement or in the system
hardware. To make sure that you never get an erroneous
measurement, the TruPulse 200X monitors both system
hardware and measurements. Error codes appear in the main
display and are in the form of “E xx”, where “xx” is an error
code number. Figure #8 shows an example error code, E 01.
Error Code Explanation
E 01 Failure to lock on target.
Reposition instrument and retake the
measurement. If you continue to receive the
error, the target maybe out of range or have no
reflective qualities.
E 50 or above Shut off unit and try again.
If the same error repeats, please contact LTI
Service Department

If an error code persists:
1.
Release and press again to try to retake the measurement.
2.
Remove and re-install the battery and then try to retake the
measurement.
3.
If the above steps do not resolve the error, contact LTI or an Authorized
LTI Distributor for assistance. Refer to the inside front cover for LTI
contact information.
Figure #8