Pre-Assembly Parts
Interior Doors
Figure 5
Step 4. Locate doors and sand front and back of doors using 220 grit sand paper. Do
this by laying door flat on top of sand paper on a flat surface. Next press down with
slight pressure moving door side to side. Once done blow out door engraved arch
and square. We are only looking to clean door for painting. At this point paint parts
and proceed on to next step.
Next install door into the hole on half assembly completed earlier. Figure 5
Step 5. Glue remaining cross frame on bottom again making sure hole is to the left.
Figure 6.
Step 6. Glue remaining inner frame rail. See figure 7. Make sure holes on the top
and bottom remain clear of glue.
Step 7. Lay the door on a flat surface inside a door frame as seen in figure 8.
DO NOT
GLUE, this is done to keep door square as the glue dries. Door frame will be glued
later….
Complete steps 4 thru 7 for remaining 3 interior doors. You should have 4 doors as
seen in Figure 9 sitting inside frames drying.
Figure 7
Figure 8
Figure 6
Figure 9
