Lars Thrane Iridium Certus 200, User & Installation Manual

Page: 114 / 141

LT-4200 User & Installation Manual Rev. 1.00 Web server
Lars Thrane A/S www.thrane.eu Page 103 of 128
Reset
The LT-4200 system supports reset to factory default. This reset functionality is only available via the web
server, see Figure 119
. By pressing ‘Reset to factory default’ and acknowledging this reset, the LT-4200
system will configure all settings to default and remove all user data (e.g. Contact List, Call History, etc.).
The LT-4200 system will reboot once the factory reset has been affected.
It is also possible to just reset the network configuration to the default settings. This enables the user to
clear any network configuration rules without resetting the entire system, which will reset the LT-4200
system to its default state.
NOTE : Using ‘Reset to factory default’ the LT-4200 system will lose all settings configured and user
data will be lost. The system will be operational again once it has rebooted.
NOTE : Using “Reset network configuration” The LT-4200 system will lose all user configuration for
the Network settings including, IP address/mask, DNS, routes and Outgoing firewall rules.
The default values for display and audio settings are displayed in Table 27 below.
Default Display and Audio settings
Display, Mode Day time
Display, Brightness 70%
Speaker volume 80%
Handset volume 60%
Ringer volume 80%
Key Beep volume 40%
Table 27: Default display and audio settings
Figure 119: Web server (Reset)