Configuration Using Web-Manager
50
WiBox™ User Guide
Pack Control
Enable Packing
Select the checkbox to enable packing on the WiBox.
Two firmware-selectable packing algorithms define how and
when packets are sent to the network. The standard algorithm
is optimized for applications in which the unit is used in a local
environment, allowing for very small delays for single
characters, while keeping the packet count low. The alternate
packing algorithm minimizes the packet count on the network
and is especially useful in applications in a routed Wide Area
Network (WAN). Adjusting parameters in this mode can
economize the network data stream.
Idle Gap Time
Select the maximum time for inactivity. The default time is 12
milliseconds.
Match 2 Byte Sequence
Use to indicate the end of a series of data to be sent as one
group. The sequence must occur sequentially to indicate to
the WiBox end of the data collection.
Match Bytes
Use to indicate the end of a series of data to be sent as one
group. Set this value to 00 if specific functions are not
needed.
Send Frame Only
After the detection of the byte sequence, indicates whether to
send the data frame or the entire buffer. Select
True
to send
only the data frame.
Send Trailing Bytes
Select the number of bytes to send after the end-of-sequence
characters.
Flush Input Buffer (Serial to Network)
With Active Connect
Select
Yes
to clear the input buffer with a connection that is
initiated from the device to the network.
With Passive Connect
Select
Yes
to clear the input buffer with a connection initiated
from the network to the device.
At Time of Disconnect
Select
Yes
to clear the input buffer when the network
connection to or from the device is disconnected.
Flush Output Buffer (Network to Serial)
With Active Connect
Select
Yes
to clear the output buffer with a connection that is
initiated from the device to the network.
With Passive Connect
Select
Yes
to clear the output buffer with a connection initiated
from the network to the device.
At Time of Disconnect
Select
Yes
to clear the output buffer when the network
connection to or from the device is disconnected.
Connection Settings - TCP
To configure a channel’s TCP settings
:
1. From the main menu, click
Connection
for either Channel 1 or Channel 2 to
display the Connection Settings page for the selected channel.
2. In the available fields, enter the following information:
Summary of Contents for WiBox
