12
3
3
:
:
G
G
e
e
t
t
t
t
i
i
n
n
g
g
S
S
t
t
a
a
r
r
t
t
e
e
d
d
This chapter describes how to get your UDS up and running in the shortest possible
time.
Installing the UDS200
The following diagram shows a properly installed unit:
Figure 3-1. UDS200 Connected to Serial Device and Network
To install the unit, complete the following steps in order. Refer to the numbers in the
previous figure.
1. Connect a serial device to your unit. See
10: Connections and Pinouts
for more
information about what kinds of device attachments the unit supports.
2. Connect an Ethernet cable to the 10/100 port.
3. Supply power to your unit using the power supply that was included in the
packaging.
Note:
The required input voltage is 9-30 VDC or 9-24 VAC
(2W maximum).
4. Supply power to the serial device.
Note:
If you encounter a problem, please see
LEDs
on page 43 for
diagnostic information.
