Lantronix SM24TBT2DPA, Install Manual

Page: 10 / 38

Lantronix
SM24TBT2DPA Install Guide
33737 Rev. L https://www.lantronix.com/ Page
10
of
38

Egress shaping and rate control

Per port
Management
DHCP Server Support DHCP server to assign IP to DHCP clients
DHCP per Port
You can assign an IP address based on the switch port the device is connected to.
This will speed up installations of IP cameras; cameras can be configured after they
are on the network. The per-port assignment allows you to know which IP was
assigned to which camera.
Link-Local Address
binding interface
Configure Link-Local IP address to a different VLAN interface. The first IP interface
entry (169.254.xx.xx) is for the default value (VLAN 1). A link-local address is a unicast
address having link-only scope that can be used to reach neighbors. All interfaces on
routers must have a link-local address. Also, ADDRCONF requires that interfaces on
hosts have a link-local address.
Event Notifications
•
Event Notification via Syslog and/or SNMP Traps
•
Event Notification with 8 Severity levels
Remote Monitoring
(RMON) Embedded RMON agent supports RMON groups 1,2,3,9 (history, statistics, alarms,
and events) for enhanced traffic management, monitoring and analysis
Port Mirroring
Traffic on a port can be mirrored to another port for analysis with a network analyzer
or RMON probe. Up to
n -1 (where n is the max number of Switch Ports) ports can be
mirrored to single destination port. A single session is supported.
UPnP
The Universal Plug and Play Forum was formed to standardize discovery and control
of networked devices. See the Open Connectivity Foundation
webpage .
s-Flow
The industry standard for monitoring high speed switched networks. It gives complete
visibility into the use of networks enabling performance optimization,
accounting/billing for usage, and defense against security threats
IEEE 802.1ab (LLDP)

Used by network devices for advertising their identities, capabilities, and
neighbors on an IEEE 802ab local area network

Support LLDP-MED extensions
Web GUI Interface Built-in switch configuration utility for browser-based device configuration
CLI For configuring / managing switch in Command Line Interface modes
Dual Image Independent primary and secondary images for backup while upgrading
SNMP
SNMP version1, 2c and 3 with support for traps, and SNMP version 3 user-based
security model (USM)
Firmware Upgrade

Web browser upgrade (HTTP/ HTTPs) and TFTP

Upgrade via the console port
NTP
Network Time Protocol (NTP) is a networking protocol for clock synchronization
between computer systems over packet-switched