4: Open-QTM 410 Carrier Board
Open-Q 410 Dev Kit User Guide
22
FTDI drivers are installed. User can also bypass the FTDI chip and have direct access to the UART TTL signal
by removing R417, R418 and installing R420, R421, and J403 (not installed by default) on the carrier board.
Figure 9 – Debug Serial UART over USB (J401)
4.5 MIPI CSI Camera Connectors
There are two different versions of the Open-Q
TM
410 carrier board.
•
Rev 0100 uses the Samtec LSHM series connector (model #: LSHM-120-02.5-L-DV-A-S-K-TR) to
connects to the Open-Q™ 5MP (OmniVision OV5640) Camera Module
•
Rev 0200 uses the JAE FI-R series connector (Model #: FI-RE41S-VF) connector to connects to the
Open-Q
TM
13MP (Sony IMX214) Camera Module
4.5.1 Open-Q
TM
Carrier Board Rev 0100
The Rev 0100 Open-Q
TM
410 carrier board has two MIPI CSI camera connectors: J701 and J702. The two
Samtec LSHM-120-02.5-L-DV-A-S-K-TR 40-pins connector are shown in the figure below.
Figure 10 – MIPI CSI Camera Connectors on Rev 0100 CB
